This page is aimed at members of the administration multisig.
This step needs to be executed by one of the multisig owners.
The validator should have provided a vote account, stSOL SPL token account, and optionally a maintainer account. In this example, we have
- Vote account:
- stSOL account:
- Maintainer account:
To be sure, we can confirm that the vote account is set up correctly with
solana vote-account as shown in the validator onboarding
docs, but a transaction that
adds a vote account will fail anyway if the vote account is not set up
solido is configured, then create
the multisig transaction:
Check that the transaction was created as expected with
If the validator will run the maintenance daemon, we also need to propose a multisig transaction to add the maintainer:
Verify the transaction:
Please share the transaction addresses with the remaining multisig members.
This step needs to be executed by the remaining multisig owners.
To approve the addition of a new validator, we need:
- To know that the validator was admitted by the LNOSG.
- The vote account, stSOL account, and maintainer account, provided by the validator.
- The multisig transaction that adds the vote account.
- Optionally, the multisig transaction that adds the maintainer.
solido is configured, and
confirm that the transactions are adding the right vote account and maintainer,
solido multisig show-transaction, as shown in the previous section. Then
approve the transactions:
If the transaction is approved by a majority, you can also go ahead and execute it:
The multisig’s program derived address (PDA) needs to have sufficient funds to execute transactions. Chorus One should have funded it during setup.
You can confirm that the transaction was executed: